||Stream alluvium (floodplain and stream-terrace deposits)
||Sand, gravel, and silt. Low to high permeability. poor to good drainage. Permeability and drainage generally are better in stream-terrace deposits than in modern flood-plain sediments.
||Flat to gently sloping.
||Deposited on flood plains and stream beds by postglacial streams. Unit may also include minor alluvial fan deposits at mouths of valleys.|
||Swamp and tidal-marsh deposits
||Peat, silt, clay and sand. Poor drainage.
||Formed by accumulation of sediments and organic material in depressions and other poorly drained areas.
||Beach and dune deposits
||Sand and gravel. High permeability. Materials are well drained, but water table is close to surface.
||Low ridges and mounds, or sloping surface.
||Occurs along modern ocean and lake shores. Includes beach sediments formed by wave and current action, and windblown sand derived from these deposits.
||Sand. Moderate to high permeability. Good drainage.
||Dune ridges and mounds or blanket deposit that conforms to surface of underlying unit.
||Windblown sand. Derived from wind erosion of glacial sediments and deposited in late-glacial to postglacial time.
||Large angular rock fragments.
||Steeply sloping rock piles at the bottoms of cliffs.
||Formed by the accumulation of rock fragments that break loose from a cliff and fall to the slope below.
||Glacial-lake bottom deposits
||Silt, clay, and sand, commonly as thin inter-stratified layers of various particle sizes. Low to moderate permeability. Poor to fair drainage.
||Flat to gently sloping except where dissected by modern streams.
||Composed largely of sediments that washed out of glacial ice and accumulated on the floors of glacial lakes. Map unit may also include a few non-glacial lake bottom deposits.
||Glacial-lake beach deposits
||Gravel and sand. Typically thin and of limited extent. High permeability. Good drainage.
||Low ridges or sloping surface. May be associated with wave-cut benches on hill sides.
||Formed by wave erosion of till or other materials along shores of glacial lakes. Lakes have since lowered or drained.
||Glacial-marine deposits (Presumpscot Formation)
||Silt, clay, and sand. Commonly a clayey silt, but sand is very abundant at the surface in some places. Locally fossiliferous. Map unit includes small areas of till, sand, and gravel that are not completely covered by marine sediment. Qps: Mostly sand, but may be underlain by silt and clay. Moderate to high permeability. Fair to good drainage. Qp: Mostly silt and clay. Low permeability. Poor drainage.
||Flat to gently sloping except where dissected by modern streams. Commonly has a branching network of steep-walled stream gullies.
||Composed of sediments that washed out of the Late Wisconsinan glacier and accumulated on the ocean floor. Formed during late-glacial time, when relative sea level was higher than at present.
||Emerged marine-beach deposits
||Gravel and sand. High permeablility. Good drainage. Typically thin and of limited extent.
||Low ridges or sloping surface. May be associated with wave-cut benches on hillsides.
||Formed by wave erosion of till or other materials during late-glacial time, when relative sea level was higher than at present.
||Sand and gravel. May include minor till. Commonly overlapped or entirely buried by glacial-marine deposits in the coastal lowland. Qgo: High permeability. Good drainage. Qg: Moderate to high permeability. Good drainage.
||Qgo: Flat (outwash deposits). Qg: Flat-topped landforms, bounded in part by steep sides (kame terraces and kame deltas); hummocky terrain with hills (kames) and depressions (kettles); or ridges (eskers).
||Deposited by meltwater streams and currents during melting of the Late Wisconsinan glacier. Qgo: Outwash plains and outwash deltas. Deposited beyond the ice margin. Qg: Kames, eskers, and marine or glacial-lake deltas - all formed adjacent to glacial ice (ice-contact deposits).
|Qmg, Qmh, Qmt, Qm
||Till and/or sand and gravel. Commonly overlain by glacial-marine deposits in coastal areas. Permeability and drainage are highly variable, even over short distances in a single moraine. Qmg: Composed mostly of sand and gravel. Qmh: Composed of till, sand, and gravel. Qmt: Composed mostly of till. Qm: Composition not specified.
||Ridges. Commonly arcuate, discontinuous, and in groups. Size range: 3-75 ft. high, 20-1,000 ft. wide, and 100 ft. to several miles long. Qmh: Hummocky topography.
||Deposited in marginal zone of the Late Wisconsinan glacier, by glacial ice (till) and/or meltwater streams emerging from the ice (sand and gravel).
||Hetergeneous mixture of sand, silt, clay, and stones. Stratification is rare. Includes two varieties: basal till and ablation till. Basal till is fine-grained and very compact, with low permeability and poor drainage. Ablation till is loose, sandy, and stony, with moderate permeability and fair to good drainage. Unit generally overlies bedrock, but may overlie or include sand and gravel.
||Commonly a blanket deposit that conforms to bedrock surface. Also forms glacially streamlined hills (including drumlins), where till thickness locally exceeds 100 feet.
||Deposited directly by glacial ice.